2026-06-07
Rudder fittings: a quick inspection
Rudders are one of the few things on a dinghy that can fail suddenly and leave you without steering. At the start of each season, we take every rudder off, lay it on the grass, and inspect the pintles and gudgeons carefully. It takes about ten minutes per boat and is well worth doing.
We look for wear first: pintles should be straight and a snug fit in the gudgeons, without more than a couple of millimetres of play. Elongated holes are a warning sign. We also check the screws and bolts holding the fittings, and replace any that are corroded, using stainless fasteners and a little sealant on the threads.
This year one gudgeon on the older boat had a hairline crack near its mounting hole. We fitted a new pair, drilled out the transom slightly, filled the old holes with epoxy thickened with fine filler, and drilled fresh ones after it had cured. It was a tidy job, and the transom is now stiffer than before.
Lastly, we tie a short lanyard from the rudder to the transom, so that if it ever jumps off, it stays attached. The cord is thin, only three millimetres, but it holds. We also keep a spare set of pins in the toolbox, and everyone knows exactly which drawer.