2026-06-16
Repairing a cracked gunwale
Last autumn, one of the dinghies took a knock against the pontoon in a gust, and a crack opened along the port gunwale about eight inches long. It was not dramatic, but water would creep into the wood and rot it if we left it. We decided to fix it properly over a couple of weekends in the shed.
First we scraped off the paint around the crack with a card scraper, then sanded back to bare wood with eighty-grit paper. We let it dry under a small heater for three days, because epoxy will not grip damp timber. Rob drilled a tiny hole at each end of the crack, to stop it spreading further.
We mixed slow-hardening epoxy with a little wood flour until it was the consistency of peanut butter, worked it deep into the crack with a plastic spreader, and clamped the gunwale firmly closed with two small G-clamps and offcuts of scrap wood. It cured overnight, and the next day we planed off the squeeze-out.
After that, a light sanding at one-twenty grit, two coats of primer and two of topcoat in the original cream colour. The patch is nearly invisible. What we would do differently is to check the gunwales more often through the season, since a small split caught early is half the work.